Worktops
Spec A - Block Board Mounted
Mounted on treated board to form a solid strong substructure to mount on Kitchen Base units.
Available with square or water retaining front profiles - See edge details below.
Available with Integral Rear up stand - See edge details below.
Available with 'dropped recess drainer ' area for water retention at the point where the sink is seamless welded in.
Spec B - Catering Spec Single Skin
NO treated board Under just a single skin catering Spec - Discrete Studs welded to under side to affix to frame supports.
Available with square or water retaining front profiles - See edge details below.
Available with Integral Rear up stand - See edge details below
Available with 'dropped recess drainer ' area for water retention at the point where the sink is seamless welded
Technical Specifications
- Stainless Steel
1.5mm thickness - 304 grade stainless steel - 18% Chromium & 20% Nickel – Corrosion Resistent. - Fabrication
240S grit stainless steel - Silicon enhanced finish.
Fabrication subject to +/- 3mm tolerance. - PDF Downloads:
EDGE SPECS
BOWL SPECS
Choose your sink, drainer and water retaining edge detail.
Recessed Drainer
- Sink seamlessly welded in to a lower section 15mm lower than the upper work surface.
- Stops water going over the front edge of the upper work surface.
- Scalloped Fluted Drainer.
- Tap Set at the Lower water retained level.
Leading edge water retaining detail.
- Sink seamlessly welded in to a lower section 15mm lower than the upper work surface.
- Stops water going over the front edge.
- Scalloped Fluted Drainer.
- Tap Set at the Lower water retained level.
Drip Trays - Inset
- Hole pre cut in the work surface In the factory.
- Can be dropped and sat on the top with a 10mm return lip Or can be seamless welded in.
- Can be supplied with No drain for removing and manual flush or fitted with a 32mm waist fitting for connection to drain.
Laser Cut Curved Profile Worktops - available on request
